Sunex-tools 4910A Manuale Utente

Navigare online o scaricare Manuale Utente per Apparecchiature Sunex-tools 4910A. Sunex Tools 4910A User Manual Manuale Utente

  • Scaricare
  • Aggiungi ai miei manuali
  • Stampa
  • Pagina
    / 10
  • Indice
  • SEGNALIBRI
  • Valutato. / 5. Basato su recensioni clienti
Vedere la pagina 0
4910A 1 rev. 02/23/07
MODEL 4910A
10 Ton Ram Kit
Operating Instructions Warning Information Parts Breakdown
Operating Instructions
RELEASE VALVE
Turn knob clockwise and pump
handle for applying pressure.
Turn knob COUNTERCLOCKWISE
to release pressure.
PUMP POSITION
It is possible to hold pump in
any position from
horizontal to vertical, but
always keep the hose end of
the pump down when above
the horizontal position.
IMPORTANT: Before attempting to raise a vehicle,
check vehicle service manual for recommended lifting
surfaces.
PORTABLE RAM KIT PUMP BLEEDING PROCEDURES:
The following bleeding procedure may be required before
initial use:
1. Open oil fill screw three or four turns.
2. Attach the ram to the pump.
3. Close the release valve and pump the ram out as far
as it will go.
4. Release the ram until the first drop of oil comes out of
the oil fill hole.
5. Tighten up the oil fill screw and release the ram all of
the way.
6. Make sure the pump is full of fluid after steps 1-5 are
completed.
This ends the bleeding procedure. The pump and ram
should be working at full stroke.
do not overload. overloading is indicated by bowing
extension tubes or slipping attachments and can result in
personal injury or damage to the equipment.
when offset attachments are used, the rated capacity is
always reduced by 50%. for each extension tube used in the
setup, the overall rated capacity is reduced an additional
50%. refer to the operating instructions provided for
typical setups and corresponding load capacities.
prior to applying a load, insure that all attachments and
extension tubes are fully engaged.
insure load is centrally applied to attachments and ram
saddle to minimize an off-center load condition.
never use this equipment without a force gauge to verify
the actual load being applied for various types of setups
used.
read, study, and understand all warnings and operating
instructions furnished with this portable ram Kit before
use. failure to heed these warnings may result in loss of
load, damage to jacK and/or failure resulting in personal
injury or property damage.
do not overload beyond rated capacity. use only
on hard, level surfaces capable of sustaining
the load. do not open oil filler plug unless ram
is fully retracted. always wear safety glasses
when using this equipment. do not use as a vehicle
lifting device or as a vehicle support. failure to heed
these warnings may result in loss of load, damage to
jacK and/or failure resulting in personal injury or
property damage.
© 2007 Sunex Tools
4910A-OpMan_022307.indd 1 2/23/07 2:32:58 PM
Vedere la pagina 0
1 2 3 4 5 6 7 8 9 10

Sommario

Pagina 1 - MODEL 4910A

4910A 1 rev. 02/23/07MODEL 4910A 10 Ton Ram Kit Operating Instructions • Warning Information • Parts BreakdownOperating Instructions RELEASE VALVET

Pagina 2 - HYDRAULIC RAM ASSEMBLY

4910A 10 rev. 02/23/07Instructions d'utilisation • Avertissements • Liste de piècesGarantía Limitada:DIRECCIÓN A EMBARCARSE:Sunex Tools: 315 Ha

Pagina 3 - OWNER/USER RESPONSIBILITY

4910A 2 rev. 02/23/07MODEL 4910A 10 TON RAM KITOperating Instructions • Warning Information • Parts BreakdownRS4940A-RSK4 Ton Ram Seal KitRS4910A-R

Pagina 4 - Limited Warranty

4910A 3 rev. 02/23/07RAMRUBBERHEADFLATBASERAM LOADNever lift a load that exceeds the capacity of the ram. Do not over-extend the ram, because it i

Pagina 5 - Ensamble portátil/

4910A 4 rev. 02/23/07Operating Instructions • Warning Information • Parts BreakdownSUNEX INTERNATIONAL, INC. WARRANTS TO ITS CUSTOMERS THAT THE COMP

Pagina 6 - RESPONSABILIDAD DEL

4910A 5 rev. 02/23/07MODELO 4910A Ensamble portátil/fuerza hidráulica - 9 toneladas métricas© 2007 Sunex ToolsInstrucciones operativas • Información

Pagina 7 - Garantie Limitée:

4910A 6 rev. 02/23/07Instrucciones operativas • Información precautoria • Esquema de los componentesCARGA DEL EJE PARA SOPORTENunca levante un ca

Pagina 8 - Mode De Fonctionnement

4910A 7 rev. 02/23/07Instrucciones operativas • Información precautoria • Esquema de los componentesGarantie Limitée:ADRESSE D'EXPÉDITION: Sun

Pagina 9 - PROPRIÉTAIRE/UTILISATEUR

4910A 8 rev. 02/23/07MODELO 4910A Ensemble portatif de vérin hydraulique - 9 tonnes métriques © 2007 Sunex ToolsMode De FonctionnementInstructions d

Pagina 10 - Garantía Limitada:

4910A 9 rev. 02/23/07B A S E PLANAB A S E PLANAInstructions d'utilisation • Avertissements • Liste de piècesCHARGE DE L’ARBRE DE SUPPORTNe sou

Commenti su questo manuale

Nessun commento